Unverified paper record
Single tree identification using airborne multibaseline SAR interferometry data
Remote Sensing of Environment · 29 Sept 2016 · 10.1016/j.rse.2016.09.018
Abstract
Remote sensing data allow large scale observation of forested ecosystems. Forest assessment benefits from information about individual trees. Multibaseline SAR interferometry (InSAR) is able to generate dense point clouds of forest canopies, similar to airborne laser scanning (ALS). This type of point cloud was generated using data from the Ka-band MEMPHIS system, acquired over a mainly coniferous forest near Vordemwald in the Swiss Midlands. This point cloud was segmented using an advanced clustering technique to detect individual trees and derive their positions, heights, and crown diameters. To evaluate the InSAR point cloud properties and limitations, it was compared to products derived from ALS and stereo-photogrammetry. All point clouds showed similar geolocation accuracies with 0.2–0.3m relative shifts. Both InSAR and photogrammetry techniques yielded points predominantly located in the upper levels of the forest vegetation, while ALS provided points from the top of the canopy down to the understory and forest floor. The canopy height models agreed very well with each other, with R² values between 0.84 and 0.89. The detected trees and their estimated physical and structural parameters were validated by comparing them to reference forestry data. A detection rate of ~90% was achieved for larger trees, corresponding to half of the reference trees. The smaller trees were detected with a success rate of ~50%. The tree height was slightly underestimated, with a R² value of 0.63. The estimated crown diameter agreed on an average sense, however with a relatively low R² value of 0.19. Very high success rates (>90%) were obtained when matching the trees detected from the InSAR-data with those detected from the ALS- and photogrammetry-data. There, InSAR tree heights were in the mean 1–1.5m lower, with high R² values ranging between 0.8 and 0.9. Our results demonstrate the use of millimeter wave SAR interferometry data as an alternative to ALS- and photogrammetry-based data for forest monitoring.
Plant phenotyping relevance
航空機SAR干渉計による点群から個体樹木を検出し、樹高・樹冠径などの植物形態形質を抽出する手法を開発・比較検証しており、森林モニタリングへの応用が中心である。
abstractThis point cloud was segmented using an advanced clustering technique to detect individual trees and derive their positions, heights, and crown diameters.
abstractTo evaluate the InSAR point cloud properties and limitations, it was compared to products derived from ALS and stereo-photogrammetry.
abstractThe detected trees and their estimated physical and structural parameters were validated by comparing them to reference forestry data.
Code and data availability
公開本文の所在を確認できませんでした。非公開または購読が必要な可能性があります。
No evidence-backed public reproduction asset is currently recorded.
This is an automatically classified, unverified record. Curator approval is required before any resource enters the Catalog.